Remington Society

I have a 2013- 572 pump, that has shot about 10,000 rounds. it has been my primary weapon for killing nutria. it has developed a jamb by double feeding from the mag when I pump the action for followup shots. it cleanly ejects the spent case but then 2 fresh rounds pop up and when the bolt goes forwa...

i have a 20 ga 870 shotgun stock on my 572 because the factory stock s to high at the comb for my scope. so any 870 20ga stock will work but the drop is a little more than the 572 factory stock.

boyds stocks should have a 20 ga 870 stock.

good luck,

Bull

no my no serial number 572 has no place for the dowel screw, the left side of the receiver is smooth. i noticed that the bolt is different than my later models also. I was curious as what is the purpose of dowel screw? 1- does it stabilize the barrel in the receiver to increase accuracy? were these ...

no my no serial number 572 has no place for the dowel screw, the left side of the receiver is smooth. i noticed that the bolt is different than my later models also. I was curious as what is the purpose of dowel screw? 1- does it stabilize the barrel in the receiver to increase accuracy? were these ...

where are the 572 collectors? somebody must have the answer to my question??

Bull

I have a no serial number 572 with the barrel stamped WD which is August 1957 manufacture date? it does not have a barrel dowel screw?? when did REM begin the barrel dowel screw and why? the receiver is grooved for a scope mount. The rifle has seen some hard use but not abuse. anything you can tell ...