Can anyone tell me how to go about loading for 44 Renington Revolver for the model 1875,

OK so I can work up a powder load from .44 Colt and I can measure the bore and make a bullet mould. My problem is what cases can be reformed to fit and what are the measurements. I can't find any thing in the books that usually help me out. Nonte's Cartridge Conversions and Cartridges of the World by Barnes.

Can you help?

44-40 will chamber but the case heads need to be thinned to cycle properly iirc.

see this thread:

viewtopic.php?f=2&t=2304

Thank you very much. Your post is a real help.

my pleasure

44.40 did not work. The base was too large. 44 special may work with a lot of swaging . 41 Magnum look the best bet but will need fire forming. As we are not alowed to do this sort of thing in the UK a friend is doing it in Switzerland. I will keep you all informed.

if by base you mean the case head,then yes it needs to be trimmed as per the link I supplied.Access to a lathe would be handy